Digitrax SE8C Kurulum Talimatları - Sayfa 2

Medya Dönüştürücü Digitrax SE8C için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Digitrax SE8C 2 sayfaları. Breakout board

Sayfayı Yazdır
Slow Motion Switch Machine Outputs:
Along the right side and right bottom edge of the board facing you are the 8 outputs for a slow mo-
tion switch machine
.
The outputs start with switch machine
1,
at the very top right. Each output is 2
terminal positions
,
so each large block has 4 outputs with 2 wire connections
each.
Each output is
labeled on the board
(please
note picture) as SM1, SM2 and so on
.
Push Button and Sensor
Inputs:
The inputs from buttons and sensors are at bottom left and
center.
The inputs for the buttons are on
the
left;
while the sensor
inputs
(labeled Detection Connections) are at the
center.
The button inputs are normally used to control switch machines as described in the above section
.
A
normally open push button is used for this by connected one side of the button to the terminal at
center left (labeled +VE Push Button Common) and the other side to one of the terminals labeled for
the buttons. Note that each button input maps to its
identical
numbered switch
.
E.g.
Button 1 controls
switch machine
1.
The inputs labeled detection common can be used by a wide range of
sensors.
Digitrax uses their
801/804 occupancy accessory as the
example.
One side of the sensor is connected to the terminal
at center left (labeled -VE Occupancy Return) and the other side is connected to the bottom center
terminal
(labeled
Detection Connections)
.
For further
information
on
sensors,
consult the Digitrax manual and website for the
SE8c.
ACCU-LITES
, Inc.
"Your DCC Center"
118
S.
Main St. STE 5
Wauconda
,
IL 60084
847-224-7914
www.acculites.com
Digitrax,
PM42
,
BDL 168 and SE8c are property of
Digitrax,
Inc