Digitrax DH126MT Hızlı Başlangıç Kılavuzu - Sayfa 2

Kontrolör Digitrax DH126MT için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Digitrax DH126MT 8 sayfaları. Complete train control

Parts List

1 DH126MT Function Decoder

1 Instruction Sheet

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Carefully remove the locomotive shell.

(Figure 1) Note the orientation to

the frame for correct re-installation.

Arrange internal wires to expose the

jumper board in the locomotive.

Remove the jumper board from the

locomotive's 21MTC pins. (Figure

2) The jumper board allows the loco

to operate on a standard DC track or

in analog mode on a DCC track. If

the loco also has a 8pin NMRA

socket, any jumpers should also

be removed.

Insert the 21MTC socket onto the ex-

posed pins. The black socket and the

decoder text should be facing up. The

socket is indexed so it will only fit on

in one configuration. (Figure 3) Seat

the decoder firmly on the pins.

Replace the loco shell on the frame.

The loco is now ready to run on your

DCC system using the factory set

address 03. See next page for cus-

tomizing some of the functions of the

DH126MT decoder.

Figure 1: Remove loco shell

Figure 2: Carefully

remove jumper board

Figure 3:

Carefully plug in decoder

— 2 —

Jumper Board

Decoder