Digitrax SDH164K1C Kullanıcı Kılavuzu - Sayfa 3

Kontrolör Digitrax SDH164K1C için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Digitrax SDH164K1C 12 sayfaları. Plug ‘n play for kato f40ph ho

Sayfayı Yazdır

light board. Retain the two screws.

3) Place SDH164K1C decoder in position shown in Figure 2 and use small pli-

ers to press in 2 motor contacts into the motor contact holes. Using 2 light

board screws removed earlier, secure the decoder in position.

4) Install the 28mm round speaker in the upper rear of the F40PH shell as

shown in Figure 3. . Ensure the speaker leads are routed out through the two

slots provided in the speaker housing edge.

5) Replace platform/walkway and couplers.

6) Reattach the two press-fit brass track power clips to the track power pads on

the decoder.

7) Install the capacitor attached to the wire harness at the rear of the casting

Speaker Installed Inside

Speaker Enclosure

using the plastic clip provided. Be sure no wires short to the casting. Trim

back and secure any unused wires so they do not short to the decoder or

frame or bind the drive shafts.

8) Inspect and test the installation before replacing the shell.

2443 Transmitter RD

Panama City, FL 32404

www.digitrax.com

Figure 3: Speaker Installation Diagram

www.digitrax.com

850-872-9890

850-872-9557