Digitrax SoundFX SDXH186MT Manuel - Sayfa 4

Kontrolör Digitrax SoundFX SDXH186MT için çevrimiçi göz atın veya pdf Manuel indirin. Digitrax SoundFX SDXH186MT 16 sayfaları. Complete train control

Customizing Your Decoder

Your Digitrax SDXH186MT SoundFX decoder is ready to run and will

operate and generate sound (with an installed speaker) using address 03

with no additional programming. On your Digitrax system, simply select

the locomotive's address and the sound will start. On some DCC systems,

it is necessary to select the locomotive address AND send a command to

start the sounds.

For a more prototypical railroading experience, your decoder can be

customized for your specific locomotive by programming some of the

Configuration Variables, or CVs, available. Digitrax Sound decoders can

be programmed using either a programming track or with the operations

mode using the main line. See the Digitrax Decoder Manual or the Digi-

trax web site for more information.

CAUTION: Programming track must not exceed 16V when

programming this decoder.

Initial Test and Programming: This decoder is preprogrammed and

tested with a diesel locomotive sound scheme, and is ready to operate on

factory default address 03. Before customizing the decoder it is useful

to run it on the factory default address 03 to check the installation. The

following sections show how to change the locomotive address and cus-

tomize the decoder.

For more information on general decoder installation and programming

techniques and examples visit www.digitrax.com

Changing the Decoder Address

The first CV most people change is the decoder address. This allows

you to independently control each loco with a unique address. Digitrax

decoders are shipped with CV01 (AD2), the two digit address, set to 03.

Following is a brief description of how to change the decoder address

with a Digitrax DT4XX series throttle. See your Starter Set Manual for

complete programming instructions.

Place the loco on the programming track not to exceed 16V.

Go into Program Mode on your system. On DT4XX throttle press

PROG.

— 4 —