Cisco SCE8000 10 GBE Hızlı Başlangıç Kılavuzu - Sayfa 23

Ağ Donanımı Cisco SCE8000 10 GBE için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco SCE8000 10 GBE 25 sayfaları. 10 gbe power supply

Sayfayı Yazdır

Identifying Startup Issues

Startup issues are commonly due to a powers source issue or a poor cable connection.

This section describes the normal startup sequence and describes the steps to take if the system does not perform that sequence

as expected. LEDs indicate all system states in the startup sequence. By checking the state of the LEDs, you can determine when

and where the system failed in the startup sequence. Use the following descriptions to isolate the problem to a subsystem, and

then proceed to the appropriate sections to try to resolve the problem.

When you start up the system by turning on the power supply switch, the following should occur:

• You should immediately hear the fans operating.

• If the Status LED is flashing orange, indicating a warning state, check the user log:

At the prompt, enter more user log

If any of the following warning messages appear, turn off the Cisco SCE 8000 platform and call technical support.

Voltage problem

–

Fan problem

–

Abnormal increase in interior temperature

–

Obtaining Documentation and Submitting a Service Request

For information on obtaining documentation, submitting a service request, and gathering additional information, see the

monthly What's New in Cisco Product Documentation, which also lists all new and revised Cisco technical documentation, at:

http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html

Subscribe to the What's New in Cisco Product Documentation as a Really Simple Syndication (RSS) feed and set content to be

delivered directly to your desktop using a reader application. The RSS feeds are a free service and Cisco currently supports

RSS Version 2.0.

Cisco and the Cisco Logo are trademarks of Cisco Systems, Inc. and/or its affiliates in the U.S. and other countries. A listing of Cisco's trademarks can be found at

www.cisco.com/go/trademarks. Third party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership

relationship between Cisco and any other company. (1005R)

Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the

document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.