Cisco SNS 3755 Donanım Kurulum Kılavuzu - Sayfa 28

Ağ Donanımı Cisco SNS 3755 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco SNS 3755 42 sayfaları.

Connecting to the appliance Locally For Setup

Appliance Default Settings

The appliance is shipped with these default settings:

• The NIC mode is Shared LOM EXT.

• The NIC redundancy is Active-Active. All Ethernet ports are utilized simultaneously.

• DHCP is enabled.

• IPv4 is enabled.

Connection Methods

There are two methods for connecting to the system for initial setup:

• Local setup—Use this procedure if you want to connect a keyboard and monitor directly to the system

• Remote setup—Use this procedure if you want to perform setup through your dedicated management

Note

Connecting to the appliance Locally For Setup

This procedure requires the following equipment:

• VGA monitor

• USB keyboard

• Either the supported Cisco KVM cable or a USB cable and VGA DB-15 cable

Step 1

Attach a power cord to each power supply in your appliance, and then attach each power cord to a grounded power outlet.

Wait for approximately two minutes to let the appliance boot to standby power during the first bootup. You can verify

system power status by looking at the system Power Status LED on the front panel. The system is in standby power mode

when the LED is amber.

Step 2

Connect a USB keyboard and VGA monitor to the appliance using one of the following methods:

Cisco Secure Network Server 3700 Series Appliance Hardware Installation Guide

Shared LOM EXT mode enables the 1-Gb/10-Gb Ethernet ports and the ports on any installed Cisco

virtual interface card (VIC) to access the Cisco Integrated Management Interface (Cisco IMC). If you

want to use the 10/100/1000 dedicated management ports to access Cisco IMC, you can connect to the

appliance and change the NIC mode as described in

Configuration Utility, on page

for setup. This procedure can use a KVM cable or the ports on the rear of the appliance.

LAN.

To configure the system remotely, you must have a DHCP server on the same

network as the system. Your DHCP server must be preconfigured with the range

of MAC addresses for this server node. The MAC address is printed on a label

that is on the pull-out asset tag on the front panel. This server node has a range

of six MAC addresses assigned to the Cisco IMC. The MAC address printed on

the label is the beginning of the range of six contiguous MAC addresses.

Setting Up the System With the Cisco IMC

26.

Installing the Appliance