Digitus 4016032445876 Hızlı Başlangıç Kılavuzu - Sayfa 6
Anahtar Digitus 4016032445876 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Digitus 4016032445876 11 sayfaları. Gigabit managed poe switch
Sayfayı Yazdır
Connect Port
Connect Ethernet port
Connect an Ethernet port of the switch to the device by RJ45 cable as the
following figure shows
Connect SFP port
The optical fiber module is grabbed from the side and inserted smoothly
along the switch SFP slot until the optical module is in close contact with
the switch.
Note: to avoid improper operation cause damage to equipment or personal
injury, please pay attention to the following matters
Excessive bending of optical fibers is not allowed, and the radius of
curvature should not be less than 10cm.
Ensure the cleanliness at the end of the fiber.
Please do not look directly at the optical fiber connector; otherwise it
may cause damage to your eyes.
Remarks: it is recommended to adopt straight line -568B international
standard connection method, as the following figure shows
Power supply socket specification
Switch power line single-phase three wire power socket, the middle foot to
ground, and the left foot on the right foot for the zero line and FireWire,
please check before the operation.
Figure 3-1 Connect Ethernet port
6