Cisco 2000 Başlangıç Kılavuzu - Sayfa 26

Sunucu Cisco 2000 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco 2000 31 sayfaları.

Sayfayı Yazdır



The password may have up to 20 alphanumeric characters. Longer passwords are not supported for LOM

users. A user's LOM password is the same as that user's system password.



Management Centers can have up to 13 LOM users.

Note:

For detailed instructions on the following tasks, see the Configuring Appliance Settings chapter in the

Firepower Management Center Configuration Guide.

To enable LOM:

Select

System > Configuration

Enable remote access using the

default gateway (or use DHCP to have these values automatically assigned).

Note:

The LOM IP address must be different from the management interface IP address of the appliance.

To enable LOM capabilities for a Firepower System user:

Select

System > User Management

that you will use for LOM access to the appliance.

On the User Configuration page, enable the

Enable the

Allow Lights-Out Management Access

Installing an IPMI Utility

You use a third-party IPMI utility on your computer to create an SOL connection to the appliance.

If your computer is running Linux or Mac OS, use IPMItool. Although IPMItool is standard with many Linux

distributions, you must install IPMItool on a Mac. First, confirm that your Mac has Apple's xCode developer tools

package installed. Also, make sure the optional components for command line development are installed ("UNIX

Development" and "System Tools" in newer versions, or "Command Line Support" in older versions). Finally,

install MacPorts and IPMItool. For more information, use your favorite search engine or see these sites:

https://developer.apple.com/technologies/tools/

http://www.macports.org/

For Windows environments, use ipmiutil, which you must compile yourself. If you do not have access to a compiler,

you can use ipmiutil itself to compile. For more information, use your favorite search engine or see this site:

http://ipmiutil.sourceforge.net/

Preconfiguring Firepower Management Centers

You can preconfigure your Management Center at a staging location (a central location to preconfigure or stage

multiple appliances) to be deployed at a target location (any location other than the staging location).

To preconfigure and deploy an appliance to a target location, perform the following steps:



Install the system on the device at the staging location.



Shut down and ship the appliance to the target location.



Deploy the appliances in the target locations.

Note:

Save all packing materials and include all reference material and power cords when repackaging the

appliance.

Cisco Firepower Management Center Getting Started Guide

, then click

Console Configuration

Physical Serial Port

before you specify the LOM IP address, netmask, and

, then either edit an existing user to add LOM permissions, or create a new user

Administrator

check box and save your changes.

Preconfiguring Firepower Management Centers

role if it is not already enabled.