Cisco 2500 Series Yapılandırma Kılavuzu - Sayfa 17

Sunucu Cisco 2500 Series için çevrimiçi göz atın veya pdf Yapılandırma Kılavuzu indirin. Cisco 2500 Series 19 sayfaları. Wireless controller
Ayrıca Cisco 2500 Series için: Kurulum Kılavuzu (12 sayfalar), Dağıtım Kılavuzu (23 sayfalar), Yapılandırma Kılavuzu (50 sayfalar), Başlangıç Kılavuzu (47 sayfalar)

Step 2

The access server is now configured properly and is ready to use. Enter the command setup

if you want to modify the parameters after the initial configuration. To perform more

complex configurations, enter the command configure. For information on configuration,

see the publication Access and Communications Servers Configuration Guide.

Checking Your Settings

You can check the value of the settings you have entered by entering at the # prompt the

command show running-config if you are running Cisco IOS Release 11.0 or later, or the

command write terminal if you are running a Cisco IOS Release earlier than 11.0:

router# show running-config

configuration register is 0x2102

Configuring interface Async6:

Default client IP address for this interface [172.16.72.16]:

Configuring interface Async7:

Default client IP address for this interface [172.16.72.17]:

Configuring interface Async8:

Default client IP address for this interface [172.16.72.18]:

The configuration you have entered is now displayed and you are asked if you

want to use the displayed configuration. If you answer no, you can begin the

configuration again. If you answer yes, the configuration will be entered and saved

in the startup configuration:

Use this configuration? [yes/no]:yes

Press RETURN to get started!

[OK]

Use the enabled mode 'configure' command to modify this

configuration.

Configuring the Cisco 2500 Series Access Server 4-17

Configuring the Access Server