Cisco 3500 Series Kurulum Kılavuzu - Sayfa 25

Sunucu Cisco 3500 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco 3500 Series 36 sayfaları.

Sayfayı Yazdır
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
Step 2
Connect one end of the cable to the GigabitEthernet 0 port on the appliance.
Step 3
Connect the other end to a switch in your network.
Ethernet Port Connector
The Cisco SNS 3515 or Cisco SNS-3595 appliance comes with six integrated dual-port Ethernet controllers.
The controllers provide an interface for connecting to 10-Mb/s, 100-Mb/s, or 1000-Mb/s networks and provide
full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the Ethernet
LAN. Cisco ISE supports multiple NICs.
To access the Ethernet port, connect a Category 3, 4, 5, 5E, or 6 unshielded twisted-pair (UTP) cable to the
RJ-45 connector on the back of the appliance.
The following table describes the UTP cable categories.
Type
10BASE-T
100BASE-TX
1000BASE-T
The following figure shows the RJ-45 port and plug.
Figure 10: RJ-45 Port and Plug
Ethernet Port Pin-out
Ethernet Port
Pin
1
2
3
4
5
6
Signal
Description
TxD+
Transmit data +
TxD-
Transmit data -
RxD+
Receive data +
Termination
No connection
network
Termination
No connection
network
RxD-
Receive data-
Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide
Description
EIA Categories 3, 4, or 5 UTP (2 or 4 pair) up to 328
ft (100 m)
EIA Category 5 UTP (2 pair) up to 328 ft (100 m)
EIA Category 6 UTP (recommended), Category 5E
UTP or 5 UTP (2 pair) up to 328 ft (100 m)
Ethernet Port Connector
21