Cisco 7513 Series Bakım - Sayfa 5

Sunucu Cisco 7513 Series için çevrimiçi göz atın veya pdf Bakım indirin. Cisco 7513 Series 20 sayfaları. Chassis replacement
Ayrıca Cisco 7513 Series için: Hızlı Başlangıç Kılavuzu (44 sayfalar), Değiştirme Talimatları Kılavuzu (26 sayfalar), Veri Sayfası (11 sayfalar), Manuel (30 sayfalar), Değiştirme Talimatları Kılavuzu (19 sayfalar), Değiştirme Talimatları Kılavuzu (22 sayfalar)

Chapter 7

Maintaining Your Cisco 7513, Cisco 7513-MX, and Cisco 7576 Router

Figure 7-3

This completes the power supply removal procedure.

For the procedure for installing power supplies in the Cisco 7513, Cisco 7513-MX, and Cisco 7576, see

the

Removing and Replacing the Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card

Cage Assembly

The card cage comprises one assembly that includes the card cage and backplane. The assembly slides

into and out of the chassis and attaches to the chassis frame with four slotted captive screws.

The following procedure requires that you first remove the processor modules from the card cage; see

the procedure in

Removing the Card Cage Assembly

Use the following procedure to remove the card cage assembly. This procedure cannot be performed with

power supplies or power supply blanks installed.

Remove all processor modules from the chassis card cage.

Step 1

Make a note of the processor module slots as you remove the processor modules. Do not stack the

processor modules on top of one another.

It is possible to remove the card cage from the chassis with the processor modules installed; however, it

is not recommended. Thirteen processor modules add 32.5 lb (14.7 kg) to the system.

Remove the power supplies. (See the

Step 2

Supplies" section on page

Step 3

With the processor modules and power supplies removed, loosen the four large captive screws located

on the card cage flanges, to the left and right of the card cage opening, as shown in

OL-5008-03 B0

Power Supply Blank (Cisco 7513, Cisco 7513-MX, and Cisco 7576)

Captive screw

"Installing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power Supplies" section on page

Figure

3-14.

7-3.)

Maintenance Procedures for the Cisco 7513, Cisco 7513-MX, and Cisco 7576

"Removing Cisco 7513, Cisco 7513-MX, and Cisco 7576 Power

Cisco 7500 Series Installation and Configuration Guide

3-27.

Figure

7-4.

7-5