Cisco AS5300 - Universal Access Server Manuel - Sayfa 10
Sunucu Cisco AS5300 - Universal Access Server için çevrimiçi göz atın veya pdf Manuel indirin. Cisco AS5300 - Universal Access Server 21 sayfaları. Access server
Ayrıca Cisco AS5300 - Universal Access Server için: Ekler (10 sayfalar), Hızlı Başlangıç Kılavuzu (25 sayfalar), Yapılandırma Kılavuzu (46 sayfalar)
Sayfayı Yazdır
If the access server is configured with fewer than three feature cards, make sure that a blank slot
cover is installed over each open slot to ensure proper airflow.
Note The access server arrives with all cards already installed, unless you order a card
separately as a spare. Refer to the Cisco AS5300 Universal Access Server Module Installation
Guide for card installation instructions.
Connecting to an Ethernet Network
You can connect the access server to an Ethernet network by using a straight-through RJ-45-to-
RJ-45 Ethernet cable to connect the Ethernet 10BaseT or 10/100BaseT port to an Ethernet hub.
(See .)
Figure 3-8 Connecting to an Ethernet Hub (10BaseT Shown)
Connecting to a WAN
You can connect the access server to a WAN in the following ways:
•
Use a straight-through RJ-45-to-RJ-45 cable to connect each T1/PRI port to an RJ-45 jack.
(See .)