Cisco C880 M4 Kullanım Kılavuzu - Sayfa 7

Sunucu Cisco C880 M4 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Cisco C880 M4 48 sayfaları. System event log collection
Ayrıca Cisco C880 M4 için: Servis Ek Kılavuzu (27 sayfalar), Donanım Kurulum Kılavuzu (23 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Ürün Yazılımı Güncelleme Kılavuzu (5 sayfalar)

2.Important Notes

2. Important Notes

In this section you will find information that you must note when using the storage subsystem.

This device complies with the relevant safety standards for IT equipment.

If you have any questions relating to setting up and operating your system in the environment where you

intend to use it, please contact your sales outlet or our customer service team.

CAUTION!

● Transport the device in its original packaging or in other suitable packaging which will protect it

against shock or impact.

● Read the notes on environmental conditions in section "Technical Data" on page 12 before setting

up and operating the device.

● If the device is brought in from a cold environment, condensation may form both inside and on the

outside of the machine.

Wait until the device has acclimatized to room temperature and is absolutely dry before starting it

up. Material damage may be caused to the device if this requirement is not observed.

● Check that the rated voltage specified on the type label is the same as the local line voltage.

● The device must only be connected to a properly grounded wall outlet (the device is fitted with a

tested and approved power cable).

● Make sure that the power sockets on the device and the protective grounded outlet of the building'

s wiring system is freely accessible.

● Switching off the device does not cut off the supply of power. To do this you must remove the

power plugs.

● Before opening the unit, switch off the device and then pull out the power plugs.

● Route the cables in such a way that they do not form a potential hazard (make sure no-one can trip

over them) and that they cannot be damaged. When connecting up a device, refer to the relevant

notes in this manual.

● Never connect or disconnect data transmission lines during a storm (lightning hazard).

● Systems which comprise a number of cabinets must use a separate fused socket for each cabinet.

● The servers and the directly connected external storage subsystems should be connected to the

same power supply distributor. Otherwise you run the risk of losing data if, for example, the central

processing unit is still running but the storage subsystem has failed during a power failure.