Cisco Firepower Management Center 750 Başlangıç Kılavuzu - Sayfa 20
Sunucu Cisco Firepower Management Center 750 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Firepower Management Center 750 42 sayfaları. Firepower management center
Sayfayı Yazdır
2.
Select
Console Configuration.
3.
Select a remote console access option:
—
Select
VGA
—
Select
Physical Serial Port
If you selected
4.
To configure LOM via SOL, enter the appropriate settings:
—
DHCP Configuration
—
to be used for LOM. The LOM IP address must be different from the management interface IP
IP Address
address of the appliance.
—
for the appliance.
Netmask
—
Default Gateway
5.
Click
.
Save
Remote console configuration for the appliance is saved. If you configured Lights-Out Management, you must
enable it for at least one user; see
Setting Up Lights-Out Management
If you need to restore a Firepower device to factory defaults and do not have physical access to the appliance,
you can use Lights-Out Management (LOM) to perform the restore process. Note that you can use Lights-Out
Management on the default (
The LOM feature allows you to perform a limited set of actions on a Firepower device, using a Serial over LAN
(SOL) connection. With LOM, you use a command line interface on an out-of-band management connection to
perform tasks such as viewing the chassis serial number, or monitoring conditions such as fan speed and
temperature.
Caution:
The Firepower Management Center 2000 and 4000 introduced Cisco's Unified Computing System
(UCS) platform into the Firepower System. These models do not support Cisco functionality that uses tools
on the baseboard management controller (BMC), such as the UCS Manager or the Cisco Integrated
Management Controller (CIMC), to make any configuration changes or firmware updates.
The syntax of LOM commands depends on the utility you are using, but LOM commands generally contain the
elements listed in the following table.
.
Table 2
LOM Command Syntax
IPMItool
(Linux/Mac)
ipmitool
n/a
-I lanplus
-H IP_address
Cisco Firepower Management Center Getting Started Guide
to use the appliance's VGA port. This is the default option.
to use the appliance's serial port, or to use LOM/SOL on a Management Center.
Physical Serial Port
, the LOM settings appear.
for the appliance (
for the appliance.
Enabling LOM and LOM Users, page
) management interface only.
eth0
ipmiutil (Windows)
ipmiutil
-V4
-J3
-N IP_address
DHCP
or
Static
).
Description
Invokes the IPMI utility.
For ipmiutil only, enables admin privileges for the
LOM session.
Enables encryption for the LOM session.
Specifies the IP address of the management
interface on the appliance.
Setting Up Lights-Out Management
37.
20