Cisco MC750 Talimatlar Kılavuzu - Sayfa 14
Sunucu Cisco MC750 için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. Cisco MC750 20 sayfaları. Firepower management center
Ayrıca Cisco MC750 için: Başlangıç Kılavuzu (42 sayfalar)
Sayfayı Yazdır
Installing the Processor Air Duct
Figure A-13
1
What to Do Next:
•
Installing the Processor Air Duct
Firepower Management Centers must operate with processor air ducts in place. The air ducts are
required for proper airflow within the chassis. It is necessary to reinstall the air ducts after any
maintenance procedures. There are some differences between chassis models which are described in the
following sections:
•
•
Installing the Processor Air Duct on Firepower Management Center 750
The procedure for installing the processor air duct on a Firepower MC750 differs depending on the
revision of the appliance (Rev. 1 or Rev. 2). See
Rev. 1 chassis. See
To install the air duct on a Firepower MC750:
Step 1
Observe the ESD precautions described in
precautions described in
Step 2
Lower the processor air duct into place.
•
Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation Guide
A-14
Installing a DIMM
2
Insert the DIMM
Replace the processor air duct in your Firepower Management Center as described in the
the Processor Air Duct" section on page
Installing the Processor Air Duct on Firepower Management Center 750, page A-14
Installing the Processor Air Duct on Firepower Management Center 1500 and 3500, page A-16
Figure A-15
Safety Warnings, page
For Rev. 1 chassis, insert the two hooks at the front of the processor air duct into the corresponding
slots on the bracket behind the two system cooling fans (see "1" in
Appendix A
Memory Upgrade Instructions for Firepower Management Centers
1
2
Close the latches
A-14.
Figure A-14
for an illustration of the Firepower MC750 Rev. 2 chassis.
Working in an ESD Environment, page A-2
A-2.
for an illustration of the Firepower MC750
Figure
A-14).
2
"Installing
and the safety