3Com OfficeConnect 3C612 Hızlı Başlangıç Kılavuzu - Sayfa 11
Ağ Yönlendiricisi 3Com OfficeConnect 3C612 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. 3Com OfficeConnect 3C612 17 sayfaları. 3com officeconnect 3c612: user guide
Ayrıca 3Com OfficeConnect 3C612 için: (İtalyanca) Kullanım Kılavuzu (16 sayfalar)
Sayfayı Yazdır
Trouble-
shooting
Common
Problems
LAN LED is Off
The Ethernet cable may not be connected or be damaged.
Make sure that the Ethernet cable is properly plugged in, or
replace it with another Ethernet cable.
PC/HUB switch is not set correctly.
The switch should be "in" if the Router is connected to a PC;
and it should be "out" if the Router is connected to a hub.
Verification and IP Address Problems
Getting a bad subnet address error.
The Router normally attempts to dynamically assign IP address-
es. Turn your static IP address off on your PC, then use the User
Manager to tell the Router that you will be using static IP
addresses. Then turn static IP addressing back on.
Getting a Verification Error.
Click Next on the error screen. You will be prompted to check
the most likely causes for the error. At any point in this process,
you can click on Retry to attempt to verify the Router again. If
you click on Done, you will exit the Install program.
ADSL LED is Blinking Orange
The ADSL cable is not connected or has been damaged.
Ensure that the ADSL cable is fully plugged in, or replace it with
another telephone cable. Otherwise, contact your ISP.
The ADSL Link is Not Stable
Wiring inside the house may be causing interference.
Make sure that any filter or splitter that you received from your
ISP is installed properly.
There is another DSL device plugged into the same phone line.
Only one DSL device can establish a DSL link at a time. Even if
the other device is powered off, it may cause interference.
Disconnect all other DSL devices.
LCP Retransmission or PPPoE Timeout
Using the User Manager, make sure you have entered the proper
VCI/VPI values from your ISP. Otherwise, contact your ISP.
Authentication Failed
The Internet Connection username and password are incorrect.
Use the User Manager to check and correct these settings.
Signal loss due to long line length, or errors such as Network Layer
Failure, Local Side Terminated, Remote Side Terminated, or PPPoE
Terminated
For any of these error conditions, contact your ISP.
9