Epson DS-560 Ağ Kılavuzu - Sayfa 9

Tarayıcı Epson DS-560 için çevrimiçi göz atın veya pdf Ağ Kılavuzu indirin. Epson DS-560 33 sayfaları. Epson connect technology
Ayrıca Epson DS-560 için: Menzil Kılavuzu (7 sayfalar), Buradan başlayın (2 sayfalar), Kurulum Kılavuzu (4 sayfalar)

Sayfayı Yazdır

DS-560

Network Guide

Hold down the Connect button on the product for at least three seconds, until the Status and Error lights on the

product flash alternately.

Press the Wi-Fi Protected Setup (WPS) button on the wireless router (access point).

Note:

If the wireless router (access point) does not have a WPS button, you can enable WPS using the software supplied

with your wireless router (access point). For more details, see the documentation supplied with the wireless router

(access point).

When the Status light on the product stays on, the connection has been established.

To scan you need to configure the scanning software on your computer.

"Configuring Scanning Software on Your Computer" on page 19

Note:

See the following section if Wi-Fi setup fails.

"Cannot connect to access point" on page 25

WPS PIN code

To perform the setup, enter eight numbers (PIN code) into the wireless router (access point). The PIN code for the

product is 01234565.

Set the connection mode switch on the product to AP mode.

Note:

Even though the WPS PIN code method sets up the product for an infrastructure network, you need to set the

connection mode switch to AP mode in this step.

Using Product via Network