Cisco ONS 15600 Kart Ayarlarını Değiştir - Sayfa 13
Sunucu Cisco ONS 15600 için çevrimiçi göz atın veya pdf Kart Ayarlarını Değiştir indirin. Cisco ONS 15600 14 sayfaları. Install the bay and backplane connections
Ayrıca Cisco ONS 15600 için: Referans Kılavuzu (29 sayfalar), Manuel (10 sayfalar), Referans Kılavuzu (22 sayfalar), Kurulum Talimatları Kılavuzu (14 sayfalar)
Sayfayı Yazdır
Chapter 11
Change Card Settings
You can repeat Steps
Step 6
Stop. You have completed this procedure.
NTP-E125 Change Card Service State
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Complete the
card service state.
Click the Inventory tab.
Step 2
Click Admin State for the card you want to change, and choose an Admin state from the drop-down list:
Step 3
IS (In-Service) or OOS,MT (Out-of-Service,Maintenance).
Click Apply.
Step 4
If an error message opens indicating that the card state cannot be changed from its current state, click
Step 5
OK.
Table 11-5
information about the enhanced state model and card state transitions, refer to the "Administrative and
Service States" appendix of the Cisco ONS 15600 Reference Manual.
Table 11-5
Admin State
IS
IS
IS
OOS,MT
February 2008
4
and
5
for any other ports on that card.
This procedure changes card service state.
None
Chapter 2, "Install Cards and Fiber-Optic Cable"
As needed
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
lists possible card service state transitions based on the Admin State chosen. For more
Cisco ONS 15600 Card State Transitions
Original Service State
OOS-AUMA,MT & UEQ
(Out-of-Service and Autonomous
Management,Maintenance and
Unequipped)
OOS-AUMA,MEA & MT
(Out-of-Service and Autonomous
Management,Mismatched Equipment and
Maintenance)
OOS-MA,MT
(Out-of-Service and
Management,Maintenance)
OOS-AU,MEA
(Out-of-Service and
Autonomous,Mismatched Equipment)
NTP-E125 Change Card Service State
at the node where you want to change the
Next Service State
OOS-AU,UEQ
(Out-of-Service &
Autonomous,Unequipped)
OOS-AU,MEA
(Out-of-Service and
Autonomous,Mismatched Equipment)
IS-NR
(In-Service and Normal)
OOS-AUMA,MT & UEQ
(Out-of-Service and Autonomous
Management,Maintenance and
Unequipped)
Cisco ONS 15600 Procedure Guide, R5.0
11-13