Cisco Profile Series Kullanıcı Kılavuzu - Sayfa 26

Sunucu Cisco Profile Series için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Cisco Profile Series 44 sayfaları. Jbod on the 12g sas modular raid controller
Ayrıca Cisco Profile Series için: Başlangıç Kılavuzu (41 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Başlangıç Kılavuzu (35 sayfalar), Hızlı Referans Kılavuzu (2 sayfalar), Kurulum Kılavuzu (44 sayfalar), Yapılandırma Kılavuzu (13 sayfalar), Kurulum Sayfası (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Hızlı Başlangıç Kılavuzu (4 sayfalar), Kurulum Kılavuzu (16 sayfalar), Başlangıç Kılavuzu (32 sayfalar), Manuel (16 sayfalar), Başlangıç Kılavuzu (42 sayfalar), Başlangıç Kılavuzu (46 sayfalar)

Sayfayı Yazdır
Cisco Profile Series Kullanıcı Kılavuzu
Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200
Contents
Getting started

Layout control

This applies to multisite calls and to point-to-point calls with a presentation running.
You may alter the screen
layout when you are in a call.
To do this start by tapping
More ...
Takes you one
The one who
menu level back
speaks get the
full screen.
Nothing else is
shown.
D14582.07
User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
Placing calls
Using directories
... then tap Layout ...
The one who
The one who
speaks gets the
speaks gets the
main frame. The
main frame. The
others are shown
others are shown
as PiP (Picture in
as images below
Picture).
the main frame.
In-call features
In-call features
All participants are
shown in frames
of identical sizes.
26
Settings
Contact us
... and finally select your
preferred layout.
When a presentation
is included in a call, all
participants will be shown
above the presentation,
instead of below. This will
provide a better feeling of eye
contact.
Full screen will show the
presentation only.
Observe that changes to this
set of layouts made by the
TC-console utility are not
supported and will be ignored.
www.cisco.com
User guide