Cisco SNS-3415 series Kurulum Kılavuzu - Sayfa 26

Sunucu Cisco SNS-3415 series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco SNS-3415 series 36 sayfaları. Sns-3400 series
Ayrıca Cisco SNS-3415 series için: Kurulum Kılavuzu (19 sayfalar), Sorun Giderme Kılavuzu (8 sayfalar)

Sayfayı Yazdır

Install the Side Rails

Note

The mounting pegs that protrude through the rack-post holes are designed to fit round or square holes, or

smaller #10-32 round holes when the mounting peg is compressed. If your rack has #10-32 rack-post holes,

align the mounting pegs with the holes and then compress the spring-loaded pegs to expose the #10-32 inner

peg.

c) Expand the length-adjustment bracket until the rear mounting pegs protrude through the desired holes in the rear rack

post.

Use your finger to hold the rear securing latch open when you insert the rear mounting pegs to their holes. When you

release the latch, it wraps around the rack post and secures the slide-rail assembly.

Figure 5: Attaching a Slide Rail Assembly

Front-left rack post

Front mounting pegs

Slide-rail assembly

d) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are

level and at the same height with each other.

e) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.

Step 3

Insert the server into the slide rails:

Note

The inner rails are pre-attached to the sides of the server at the factory. You can order replacement inner rails

if these are damaged or lost (Cisco PID UCSC-RAIL1-I).

a) Align the inner rails that are pre-attached to the server sides with the front ends of the empty slide rails.

b) Push the server into the slide rails until it stops at the internal stops.

Cisco SNS-3400 Series Appliance Hardware Installation Guide

Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

Length-adjustment bracket

Rear mounting pegs

Rear securing latch