Cisco SNS-3515 series Manuel - Sayfa 17

Sunucu Cisco SNS-3515 series için çevrimiçi göz atın veya pdf Manuel indirin. Cisco SNS-3515 series 41 sayfaları. Sns 3500 series
Ayrıca Cisco SNS-3515 series için: Donanım Kurulum Kılavuzu (41 sayfalar), Sorun Giderme Kılavuzu (8 sayfalar)

Sayfayı Yazdır

Install Cisco ISE Software on the SNS 3515 and SNS 3595 Appliances

On the outside of the assembly, push the green arrow button toward the rear to open the securing plate.

Figure 6: Front Securing Mechanism, Inside of Front End

Front mounting pegs

Rack post

Step 3

Install the outer slide rails into the rack:

a) Align one slide-rail assembly front end with the front rack-post holes that you want to use. The slide rail front-end

wraps around the outside of the rack post and the mounting pegs enter the rack-post holes from the outside-front (see

the figure above).

The rack post must be between the mounting pegs and the open securing

Note

plate.

b) Push the mounting pegs into the rack-post holes from the outside-front.

c) Press the securing plate release button, marked PUSH. The spring-loaded securing plate closes to lock the pegs in

place.

d) Adjust the slide-rail length, and then push the rear mounting pegs into the corresponding rear rack-post holes. The

slide rail must be level front-to-rear.

The rear mounting pegs enter the rear rack-post holes from the inside of the rack post.

e) Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail assemblies are

at the same height with each other and are level front-to-back.

f) Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops and lock in place.

Step 4

Insert the server into the slide rails:

Install the Cisco SNS 3515 or 3595 Appliance in a Rack

Securing plate shown pulled back to open position

Cisco Identity Services Engine Hardware Installation Guide, Release 2.0.1