Cisco SNS-3515-K9 Yazılım Kurulumu - Sayfa 19

Sunucu Cisco SNS-3515-K9 için çevrimiçi göz atın veya pdf Yazılım Kurulumu indirin. Cisco SNS-3515-K9 38 sayfaları.
Ayrıca Cisco SNS-3515-K9 için: Kurulum Kılavuzu (36 sayfalar)

Sayfayı Yazdır

Install Cisco ISE Software on Cisco SNS Appliances

Figure 9: Reverse the CMA

CMA tab on end of width-adjustment slider

Connect Cables

This section describes how to connect your Cisco SNS-3515 or Cisco SNS-3595 appliance to the network

and the appliance console.

•

Attach cables (such as keyboard, monitor cables, if required) to the rear of the server. Route the cables properly

and use the cable straps to secure the cables to the slide rails. See the

Back Panel View, on page 5

Connect the Network Interface

Warning

Warning: Do not work on the system or connect or disconnect cables during periods of lightning activity.

Statement 1001

This section describes how to connect the Cisco SNS-3515 or Cisco SNS-3595 appliance Ethernet port.

The Ethernet connector supports Serial over LAN (SOL) cables. The RJ-45 port supports standard

straight-through and crossover Category 5 unshielded twisted-pair (UTP) cables. Cisco does not supply

Category 5 UTP cables; these cables are available commercially.

To connect the cable to the appliance Ethernet port:

Step 1

Verify that the appliance is turned off.

Connect the Network Interface, on page 19

Connect the Console, on page 21

Connect the Keyboard and Video Monitor, on page 21

Cable Management, on page 22

for reference on the rear view of the appliance.

Metal button for rotating

Cisco SNS 3515 or SNS 3595 Appliance

Install Cisco ISE Software on Cisco SNS Appliances

Connect Cables