Cisco SNS-3515-K9 Yazılım Kurulumu - Sayfa 24

Sunucu Cisco SNS-3515-K9 için çevrimiçi göz atın veya pdf Yazılım Kurulumu indirin. Cisco SNS-3515-K9 38 sayfaları.
Ayrıca Cisco SNS-3515-K9 için: Kurulum Kılavuzu (36 sayfalar)

Sayfayı Yazdır

Remote Connection Procedure

c) Continue with

Remote Connection Procedure

Step 1

Attach a power cord to each power supply unit in your server, and then attach each power cord to a grounded AC power

outlet. See

Power Specifications, on page 13

Wait for approximately two minutes to let the server boot in standby power during the first bootup.

You can verify system power status by looking at the system Power Status LED on the front panel (see

on Cisco SNS 3515 and 3595 Appliances, on page

Step 2

Plug your management Ethernet cable into the dedicated management port on the rear panel (see

3595 Appliance Back Panel View, on page

Step 3

Allow your preconfigured DHCP server to assign an IP address to the server node.

Step 4

Use the assigned IP address to access and log in to the Cisco IMC for the server node. Consult with your DHCP server

administrator to determine the IP address.

Note

The default user name for the server is admin. The default password is password.

Step 5

From the Cisco IMC Server Summary page, click Launch KVM Console. A separate KVM console window opens.

Step 6

From the Cisco IMC Summary page, click Power Cycle Server. The system reboots.

Step 7

Select the KVM console window.

Note

The KVM console window must be the active window for the following keyboard actions to work.

Step 8

When prompted, press F8 to enter the Cisco IMC Configuration Utility. This utility opens in the KVM console window.

This utility has two windows that you can switch between by pressing F1 or F2.

Step 9

Continue with

Setup CIMC Configuration Utility, on page

Cisco Integrated Management Controller

You can monitor the server inventory, health, and system event logs by using the built-in Cisco Integrated

Management Controller (CIMC) GUI or CLI interfaces. See the user documentation for your firmware release

at the following URL:

http://www .cisco.com/c/en/us/support/servers-unified-computing/ucs-c-series-integrated-management-controller/products-installation-and-configuration-guides-list.html

Note

You must use the versions of CIMC firmware from the ISE downloads, which are qualified versions for use

with the SNS appliances. Versions of CIMC for UCS are not compatible. Newer versions of CIMC are

developed for SNS appliances after they are developed for UCS.

Check the download directory for release notes or upgrade instructions.

Install Cisco ISE Software on Cisco SNS Appliances

Setup CIMC Configuration Utility, on page

for power specifications.

5).

Install Cisco ISE Software on Cisco SNS Appliances

25.

2). The system is in standby power mode when the LED is amber.

25.

LED Indicators

Cisco SNS 3515 or SNS