Cisco SNS-3595-K9 Kurulum Kılavuzu - Sayfa 27

Sunucu Cisco SNS-3595-K9 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco SNS-3595-K9 36 sayfaları.
Ayrıca Cisco SNS-3595-K9 için: Yazılım Kurulumu (38 sayfalar)

Sayfayı Yazdır

Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances

The Cisco SNS-3515 or Cisco SNS-3595 appliance does not provide support for a mouse.

The Cisco SNS-3515 or Cisco SNS-3595 provides USB ports on the rear of the appliance that can be used to

connect a keyboard and video monitor.

To connect a keyboard and video monitor to the appliance:

Step 1

Verify that the appliance is turned off.

Step 2

Connect the end of the keyboard cable to the PS/2 (keyboard) port which is located on the back panel of the appliance.

Step 3

Connect the end of the video monitor cable to the PS/2 (video monitor) port which is located on the back panel of the

appliance.

Step 4

Power on the appliance.

Cable Management

Cable management is the most visual aspect of your appliance setup. However, cable management is often

overlooked because it can be time consuming.

Equipment racks and enclosures house more equipment today than ever before. This growth has increased

the need for organized cable management both inside and outside the rack. Poor cable management not only

leads to damaged cables or increased time for adding or changing cables, but also blocks critical airflow or

access. These problems can lead to inefficiencies in the performance of your equipment or even downtime.

There are many solutions to address cable management. They can range from simple cable management rings,

to vertical or horizontal organizers, to troughs and ladders.

All Cisco SNS-3515 or Cisco SNS-3595 appliance cables should be properly dressed so as not to interfere

with each other or other pieces of equipment. Use local practices to ensure that the cables attached to your

appliance are properly dressed.

Proceed to the next section,

continue the installation process.

Connect and Power On the Cisco SNS 3515 or 3595 Appliance

•

Connect and Power On the Server (Standalone Mode)

Note

This section describes how to power on the server, assign an IP address, and connect to server management

when using the server in standalone mode.

The server is shipped with the following default settings:

• The NIC mode is Shared LOM EXT.

Connect and Power On the Cisco SNS 3515 or 3595 Appliance, on page

Connect and Power On the Server (Standalone Mode), on page 23

Cisco Integrated Management Controller, on page 25

NIC Modes and NIC Redundancy Settings, on page 28

Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide

Cable Management

23, to