Cisco Sourcefire Defense Center 750 Başlangıç Kılavuzu - Sayfa 6
Sunucu Cisco Sourcefire Defense Center 750 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Sourcefire Defense Center 750 31 sayfaları. Network management device
Ayrıca Cisco Sourcefire Defense Center 750 için: Hızlı Başlangıç Kılavuzu (4 sayfalar)
Sayfayı Yazdır
6.
Enter the netmask for the interface's IP address or press Enter to accept the current value. For example:
255.255.255.0
The following prompt (appended with the current value) appears:
Management gateway?
7.
Enter the gateway for the interface's IP address or press Enter to accept the current value. For example:
10.2.1.1
The following prompt appears:
Are these settings correct: (y or n)?
8.
If the settings are correct, type y and press Enter to accept the settings and continue.
If the settings are incorrect, type n and press Enter. You are prompted to enter the information again.
9.
After you have accepted the settings, log out of the shell.
What to Do Next
Complete the setup process using the procedures in
Initial Setup Page: Management Centers
For all Management Centers, you must complete the setup process by logging into the Management Center's web
interface and specifying initial configuration options on a setup page. You must change the administrator
password, specify network settings if you haven't already, and accept the EULA.
The setup process also allows you to register and license devices. Before you can register a device, you must
complete the setup process on the device itself, as well as add the Management Center as a remote manager, or
the registration will fail.
Procedure
1.
Direct your browser to
management interface:
—
For a Management Center connected to a computer with an Ethernet cable, direct the browser on that
computer to the default management interface IPv4 address:
—
For a Management Center where network settings are already configured, use a computer on your
management network to browse to the IP address of the Management Center's management interface.
2.
Log in using
admin
See the following sections for information on completing the setup:
—
Change Password, page 7
—
Network Settings, page 7
—
Time Settings, page 7
—
Recurring Rule Update Imports, page 8
—
Recurring Geolocation Updates, page 8
—
Automatic Backups, page 8
—
License Settings, page 8
—
Device Registration, page 9
Cisco Firepower Management Center Getting Started Guide
, where
https://mgmt_ip/
as the username and
Admin123
Installing the Firepower Management Center
Initial Setup Page: Management Centers, page
is the IP address of the Management Center's
mgmt_ip
https://192.168.45.45/
as the password.
6.
.
6