ES-300C SCANNER
Environmental Conditions
Temperature
Operating: 5 to 35
Storage:
Humidity
Operating: 10% to 80%; no condensation
Storage: 10% to 85%;
Dust
Ordinary office or home conditions; extreme
dust should
Do not operate under direct sunlight or near
Illumination
strong light source. Reliability under such
Reliability
Main Unit
100,000 cycles MCBF
Manuscripts
Use refractwe type documents wth smooth surfaces (such as prmtmg and
photographs).
M a m s c a n l e n g t h
O f f s e t l e n g t h -
Sub scan length -
Reading
length
The maximum printable sizes available with the direct print
function are as shown below.
Epson (80 columns
and HP Paintjet
1416 dots
(7.1
200 mm)
inch6 or
at
180 dpi)
degrees C
-25
to 60 degrees C
no condensation
avoided.
be
guaranteed.
Sub Scan
Epson Cl36 mlumn)
(9.7 inch6 or 246 mm)
2136 dots
(11.9 inchrs
or 301 mnJ
You can use any type of paper that is acceptable for your printer,
including single sheets or continuous paper. Always make sure,
however, that the paper you use is large enough to accommodate
the printable size.
You can adjust the printed size of the image with the zoom function
of the scanner. Details on the relation between zoom and printable
size are explained later in this appendix.
0 ?
CAUTION:
Never use paper smaller than the printable size
.
you choose. Printing beyond the paper can damage your
printer.
The Control Panel
POWER light
Display f%)
I
Indicator lighia
On when the scanner is ready to receive commands from the
computer software. Flkkers during scanning.
ZOOM (onllge)
On when the display is in zoom mode. Use the@ CWrease) and
display when you are using the direst print function.
On when the display is in brightness mode. Use the @ (Increase)
and @ Oecrease) buttons to change the brightnm value shown on
the display when you are using the direct print function.
The display
The LED display indicates the zoom value when the control panel is
in zoom mode and indicates the brightness value when the control
panel is in brightness mode. It also indicates when an error occurs in
the scanner. The scanner is in the zoom mode when you first tum on
the power.
Pressing this button selects either zoom mode or brightness mode.
scanner is in the ready state). The scanner
you first turn on the power. Use this button to select zoom or
brightness only when you are using the direct print function.
ZOOM light
\
is in zoom mode when
Scanners
Sayfayı Yazdır