Cisco UCS B420 M4 Kurulum ve Servis Notu - Sayfa 13
Sunucu Cisco UCS B420 M4 için çevrimiçi göz atın veya pdf Kurulum ve Servis Notu indirin. Cisco UCS B420 M4 38 sayfaları. Blade server
Sayfayı Yazdır
Servicing the Blade Server
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Removing a Blade Server Cover
Step 1
Press and hold the button down as shown in the figure below.
Step 2
While holding the back end of the cover, pull the cover back and then up.
Drive Replacement
You can remove and install hard drives without removing the blade server from the chassis.
The drives supported in this blade server come with the drive sled attached. Spare drive sleds are not available.
A list of currently supported drives is in the
Removing a Blade Server Cover, on page 11
Drive Replacement, on page 11
Air Baffles, on page 15
Internal Components, on page 17
Diagnostics Button and LEDs, on page 18
Installing a CMOS Battery, on page 18
Installing a Modular Storage Subsystem, on page 19
Upgrading to Intel Xeon E5-4600 v4 Series CPUs, on page 20
Removing a Heat Sink and CPU, on page 20
Installing a New CPU and Heat Sink, on page 22
Installing Memory, on page 24
Installing a Virtual Interface Card Adapter, on page 29
Installing an Adapter Card in Slots 2 or 3, on page 30
Enabling the Trusted Platform Module, on page 31
C H A P T E R
Cisco UCS B420 M4 Blade Server Specification
Cisco UCS B420 M4 Blade Server Installation and Service Note
3
Sheet.
11