Cisco UCS B460 M4 Kurulum ve Servis Notu - Sayfa 19

Sunucu Cisco UCS B460 M4 için çevrimiçi göz atın veya pdf Kurulum ve Servis Notu indirin. Cisco UCS B460 M4 46 sayfaları. Blade server
Ayrıca Cisco UCS B460 M4 için: Veri Sayfası (7 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Hızlı Başlangıç Kılavuzu (5 sayfalar), Kurulum ve Servis Notu (50 sayfalar)

Installing a Blade Server

Step 2

Grasp the front of the blade module and place your other hand under the blade to support it.

Figure 6: Positioning a UCS B260 M4 Blade Module in the Chassis

Step 3

Open the ejector levers in the front of the blade module.

Step 4

Gently slide the blade into the blade slot opening until you cannot push it any farther.

Step 5

Press the ejector levers so that they latch with the edge of the chassis and press the blade module all the way

in.

Step 6

Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers will

prevent stripped or damaged captive screws.

Step 7

Attach the UCS Scalability Terminator or UCS Scalability Connector to the blade module(s) as follows:

a) Line up the four captive screws on the UCS Scalability Terminator with the holes on the front of the blade

module(s).

b) Push the UCS Scalability Terminator or UCS Scalability Connector into place.

c) Tighten the captive screws on the front of the UCS Scalability Terminator or the UCS Scalability Connector.

Server Configuration

Cisco UCS blade servers should be configured and managed using Cisco UCS Manager. For details, see the

Configuration Guide for the version of Cisco UCS Manager that you are using. The configuration guides are

available at the following URL:

configuration_guides_list.html

http://www.cisco.com/en/US/products/ps10281/products_installation_and_

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs

Server Configuration