Cisco UCS C240 Kurulum Kılavuzu - Sayfa 19

Sunucu Cisco UCS C240 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco UCS C240 22 sayfaları. Connected safety and security (css)
Ayrıca Cisco UCS C240 için: Kullanıcı Kılavuzu (22 sayfalar)

Sayfayı Yazdır

Chapter 2

Installing the Server

Procedure 2: Use Recovery Jumper and recovery.cap File

See

Download the BIOS update package and extract it to a temporary location.

Step 1

Copy the contents of the extracted recovery folder to the root directory a USB thumb drive. The recovery

Step 2

folder contains the recovery.cap file that is required in this procedure.

Note

Step 3

Power off the server as described in

Step 4

Disconnect all power cords from the power supplies.

Slide the server out the front of the rack far enough so that you can remove the top cover. You might have

Step 5

to detach cables from the rear panel to provide clearance.

Caution

Remove the top cover as described in

Step 6

Remove PCIe riser 1 and set it aside to provide clearance for accessing the header. See

Step 7

Riser, page

Move the shorting jumper to pins 2 and 3 of the J2068 header (see

Step 8

Reconnect AC power cords to the server. The server powers up to standby power mode.

Step 9

Step 10

Insert the USB thumb drive that you prepared in

Return the server to main power mode by pressing the Power button on the front panel.

Step 11

The server boots with the updated BIOS boot block. When the BIOS detects a valid recovery.cap file on

the USB thumb drive, it displays this message:

Wait for server to complete the BIOS update, then remove the USB thumb drive from the server.

Step 12

Note

Step 13

After the server has fully booted, power off the server again and disconnect all power cords.

Step 14

Move the jumper back to the default pins 1 and 2 of the J41 header.

Note

Replace PCIe riser 1 to its position. See

Step 15

Replace the top cover, replace the server in the rack, replace power cords and any other cables, then

Step 16

power on the server by pressing the Power button.

OL-25761-01

for the location of the J2068 header.

Figure 2-7

The recovery.cap file must be in the root directory of the USB thumb drive. Do not rename this

file. The USB thumb drive must be formatted with either FAT16 or FAT32 file systems.

If you cannot safely view and access the component, remove the server from the rack.

3-38. You do not have to remove any cards from the riser.

Found a valid recovery file...Transferring to CIMC

System would flash the BIOS image now...

System would restart with recovered image after a few seconds...

During the BIOS update, the CIMC will shut down the server and the screen will be blank for

about 10 minutes. Do not unplug the power cords during this update. The CIMC will power on

the server after the update is complete.

If you do not move the jumper, after recovery completion you see the prompt, "Please remove

the recovery jumper."

Shutting Down and Powering Off the Server, page

Removing and Replacing the Server Top Cover, page

Step 2

into a USB port on the server.

Replacing a PCIe Riser, page

Cisco UCS C240 Server Installation and Service Guide

Service Headers and Jumpers

3-7.

3-8.

Replacing a PCIe

Figure

2-7).

3-38.

2-19