Cisco 2600 Series Kurulum Kılavuzu - Sayfa 6

Ağ Geçidi Cisco 2600 Series için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco 2600 Series 12 sayfaları. Configuring adsl wic to support pppoe clients
Ayrıca Cisco 2600 Series için: Sürüm Notları (32 sayfalar), Konfigürasyon (15 sayfalar), Uygulama Notu (41 sayfalar), Veri Sayfası (6 sayfalar), Ekler (15 sayfalar), Kurulum Kılavuzu (22 sayfalar), Genel Bakış (13 sayfalar), Hızlı Başlangıç Kılavuzu (2 sayfalar), Manuel (5 sayfalar)

Cisco 2600 Series Kurulum Kılavuzu
Removing the Cover
Take these steps to remove the chassis cover:
Step 1
Step 2
Step 3
Warning
contact with telephone-network voltages.
Warning
lightning activity.
Step 4
Step 5
Figure 2
Step 6
Figure 3
Step 7
6 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers
Power OFF the router.
Attach an ESD-preventive wrist strap.
Disconnect all cables from the rear panel of the router.
Before opening the chassis, disconnect the telephone-network cables to avoid
Do not work on the system or connect or disconnect cables during periods of
Place the router so that the front panel is facing you. Remove the screws located on top
of the cover near the front edge.
Slide the cover away from you until the metal tabs on the side edges separate from the
chassis bottom, as shown in Figure 2.
Removing the Cover
POWER
RPS
ACTIVITY
Lift the front edge of the cover until it clears the front of the chassis, as shown in Figure 3.
Lifting the Cover
POWER
RPS
ACTIVITY
Lift the cover until it is free from the chassis and then set it aside.
Cisco 2600
SERIES
Cisco 2600
SERIES