Cisco 2800 Series Konfigürasyon - Sayfa 4

Ağ Geçidi Cisco 2800 Series için çevrimiçi göz atın veya pdf Konfigürasyon indirin. Cisco 2800 Series 10 sayfaları. Cisco ios software configuration
Ayrıca Cisco 2800 Series için: Hızlı Başlangıç Kılavuzu (13 sayfalar), Veri Sayfası (8 sayfalar), Hızlı Başlangıç Kılavuzu (47 sayfalar), Uygulama Notu (41 sayfalar), Hızlı Başlangıç Kılavuzu (45 sayfalar), Genel Bakış (27 sayfalar), Veri Sayfası (5 sayfalar), Veri Sayfası (20 sayfalar), Yapılandırma (32 sayfalar)

Sayfayı Yazdır
Cisco 2800 Series Konfigürasyon

Configuring the Router

Table 1
Cisco 2800 Series LED Indicators
LED Label
LED Color or State
AUX/
Green
PWR
Amber
Off
SYS
Blinking green or solid green
ACT
Off
CF
Blinking green or solid green
Off

Verifying the Hardware Configuration

To display and verify the hardware features, enter the following commands:
•
•
Configuring the Router
This section covers the following topics:
•
•
•
•
•
You can configure your router by using one of the following tools:
•
•
•
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
10
IP phone power operating normally (if installed), or
Cisco Redundant Power System (RPS) operating normally (if installed)
IP phone power fault (if installed), or
Cisco Redundant Power System (RPS) fault (if installed)
IP phone power and Cisco RPS are not installed
Packet transfers are occurring or internal monitoring activities are
occurring
No packet transfers are occurring
Flash memory is being accessed; do not eject the CompactFlash memory
card
Flash memory is not being accessed; okay to eject the CompactFlash
memory card
show version-Displays the system hardware version; the installed software version; the names and
sources of configuration files; the boot images; and the amount of installed DRAM, NVRAM, and
flash memory.
show diag-Lists and displays diagnostic information about the installed controllers, interface
processors, and port adapters; typical examples are network modules, interface cards (VICs, WICs,
HWICs), and advanced integration modules (AIMs).
Cisco Router and Security Device Manager-See the
Security Device Manager" section on page
Setup command facility-See the
on page
5.
Command-line interface (CLI)-See the
Configuration" section on page
Meaning
"Initial Configuration Using Cisco Router and
5.
"Initial Configuration Using the Setup Command Facility" section
"Initial Configuration Using the Cisco CLI-Manual
8.
OL-5788-01