Cisco 3600 Series Ekler - Sayfa 8

Ağ Geçidi Cisco 3600 Series için çevrimiçi göz atın veya pdf Ekler indirin. Cisco 3600 Series 15 sayfaları. Memory upgrade
Ayrıca Cisco 3600 Series için: Ürüne Genel Bakış (10 sayfalar), Yükseltme Talimatları (30 sayfalar), Kullanıcı El Kitabı (17 sayfalar), Uygulama Notu (41 sayfalar), Yapılandırma Kılavuzu (36 sayfalar), Kullanıcı Kılavuzu (25 sayfalar), Kullanıcı Kılavuzu (7 sayfalar), Manuel (5 sayfalar), Yapılandırma Notu (23 sayfalar), Yapılandırma Notu (18 sayfalar), Yapılandırma Notu (25 sayfalar)

Caller ID Configuration Task List

Configuring FXS and FXO Voice Ports to Support Caller ID

To configure caller-ID on FXS and FXO voice ports, use the following commands beginning in global

configuration mode:

Command

Step 1

Router(config)# caller-id enable

Step 2

Router(config-voiceport)# station-id name name

Cisco IOS Voice, Video, and Fax Configuration Guide

VC-818

Caller ID on Cisco 2600 and 3600 Series Routers and Cisco MC3810 Multiservice Concentrators

Purpose

Enables caller ID. This command applies to FXS

voice ports that send caller-ID information and to

FXO ports that receive it. By default caller ID is

disabled.

Note

Configures the station name on FXS voice ports

connected to user telephone sets. This sets the

caller-ID information for on-net calls originated by

the FXS port. You can also configure the station name

on an FXO port of a router for which incoming Caller

ID from the PSTN subscriber line is expected. In this

case, if no caller-ID information is included on the

incoming PSTN call, the call recipient receives the

information configured on the FXO port instead. If

the PSTN subscriber line does provide caller-ID

information, this information is used and the

configured station name is ignored.

The name argument is a character string of 1 to 15

characters identifying the station.

Note

If the station-id or a caller-id alerting

command is configured on the voice port,

these automatically enable caller ID, and the

caller-id enable command is not necessary.

This command applies only to caller-ID calls,

not Automatic Number Identification (ANI)

calls. ANI supplies calling number

identification only.