Digitus DN-651103 Manuel - Sayfa 5
Ağ Yönlendiricisi Digitus DN-651103 için çevrimiçi göz atın veya pdf Manuel indirin. Digitus DN-651103 8 sayfaları. Industrial 10/100/1000m ethernet switch with poe+
Sayfayı Yazdır
POWER CONNECTION
This unit provides 6 pin terminal block, which can be operated using
either 12 VDC, 24 VDC, or 48VDC power source. The VDC power range
can be 48VDC only, or wide range from 12VDC to 55VDC.
WARNING –
any exceeded input voltage will not make this unit function and may
damage this unit.
Relay – You may use 24V@1A relay connection to your external device
for special purpose. When 2 powers are connected, the relay is in
SHORT mode. When any power source fails, the relay change, it's in
OPEN status.
POWER CONNECTING PROCEDURE
STEP 1 – Pull out 6 pin terminal block.
STEP 2 – Connect wire to V1+, V1-, or V2+, V2-,
and Ground the neutral wire to the ground screw.
STEP 3– Plug back 6 pin terminal block to its place.
WARNING
Always ground the power source to maintain a clean power input. Due to
too many cheap made power supplies, it creates too much noise, and it
will cause the power input fluctuates when connect to this unit. To avoid
this, always ground the power source to gain a clean power input.
To make power connection – Follow the
printed polarity for V1+, V1-, V2+, V2-, and
ground. Connect positive wire to V+,
connect negative wire to V-, also connect
the neutral wire to the ground screw as
shown.