Cisco ASR 9000 Series Ağ Ayarlarını Yapılandırma - Sayfa 22
Ağ Geçidi Cisco ASR 9000 Series için çevrimiçi göz atın veya pdf Ağ Ayarlarını Yapılandırma indirin. Cisco ASR 9000 Series 26 sayfaları. Line card
Ayrıca Cisco ASR 9000 Series için: Yapılandırma Kılavuzu (46 sayfalar), Yapılandırma Kılavuzu (50 sayfalar), Manuel (24 sayfalar), Yapılandırma (46 sayfalar), Manuel (44 sayfalar), Hızlı Referans Kılavuzu (7 sayfalar)
Configuration Examples for Satellite nV System
Configuration Examples for Satellite nV System
This section contains these examples:
•
Satellite System Configuration: Example
This example shows a sample configuration for setting up the connectivity of a Satellite System.
Satellite Global Configuration
The satellite ID, type, serial number, description, and satellite IP address are configured in the satellite
global configuration submode:
nv
satellite 100
type asr9000v
serial-number CAT1521B1BB
description milpitas bldg20
ipv4 address 10.0.0.100
!
!
ICL (satellite-fabric-link) Interface Configuration
On the interface connected to the satellite (TenGig or Bundle interface), the ports associated with the
satellite ID must be specified. All fabric links connected to the same satellite must use the same (host)
IPv4 address. The same or different host IPv4 addresses can be used for the same host to connect to
different satellites.
interface Loopback1000
ipv4 address 10.0.0.1 255.0.0.0
interface TenGigE0/2/1/0
description To Sat5 1/46
ipv4 point-to-point
ipv4 unnumbered Loopback1000
nv
satellite-fabric-link satellite 200
remote-ports GigabitEthernet 0/0/0-30
!
!
!
These examples illustrate using IP addresses from the global VRF of the router for satellite management
Note
traffic. As discussed
done using a private VRF, to prevent IP address conflict with the global VRF. In this case, the loopback
interface and the ICL interfaces in the examples must be assigned to the private VRF dedicated for
satellite management traffic.
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Configuration Guide
HC-728
Configuring the Satellite Network Virtualization (nV) System on the Cisco ASR 9000 Series Router
Satellite System Configuration: Example, page 728
Satellite Global Configuration, page 728
–
ICL (satellite-fabric-link) Interface Configuration, page 728
–
Satellite Interface Configuration, page 729
–
Satellite Management using private VRF, page 729
–
Satellite Discovery and Control Protocol IP Connectivity
section, this can also be
OL-26061-03