Cisco ASR 9000 Series Yapılandırma - Sayfa 35

Ağ Geçidi Cisco ASR 9000 Series için çevrimiçi göz atın veya pdf Yapılandırma indirin. Cisco ASR 9000 Series 46 sayfaları. Line card
Ayrıca Cisco ASR 9000 Series için: Ağ Ayarlarını Yapılandırma (26 sayfalar), Yapılandırma Kılavuzu (46 sayfalar), Yapılandırma Kılavuzu (50 sayfalar), Manuel (24 sayfalar), Manuel (44 sayfalar), Hızlı Referans Kılavuzu (7 sayfalar)

Sayfayı Yazdır
Cisco ASR 9000 Series Yapılandırma
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Command or Action
Step 6
mode tug3
Example:
RP/0/0/CPU0:router(config-auPath)# mode
tug3
Step 7
width number
Example:
RP/0/0/CPU0:router(config-auPath)# width
3
Step 8
tug3 number
Example:
RP/0/0/CPU0:router(config-auPath)#tug3 1
Step 9
mode mode
Example:
RP/0/0/CPU0:router(config-tug3Path)# mode
e3
Step 10
root
Example:
RP/0/0/CPU0:router(config-tug3Path)# root
Step 11
controller name instance
Example:
RP/0/0/CPU0:router(config)# controller e3
0/1/1/0/0/0
OL-26061-03
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Sets the mode of interface at the AU level. Currently only TUG3 is
supported.
Configures the number of the AU streams.
Specifies the Tributary Unit Group (TUG) number and enters the
config-tug3Path mode. The range is 1 to 3.
Sets the mode of interface at the tug3 level. The modes are:
c11—TUG-3 path carrying TU-11
•
c11-t1—TUG-3 path carrying TU-11 to T1
•
c12—TUG-3 path carrying TU-12
•
c12-e1—TUG-3 path carrying TU-12 to E1
•
e3—TUG-3 path carrying E3
•
•
t3—TUG-3 path carrying T3
Note
The 1-Port Channelized OC-48/STM-16 SPA only supports
the e3 and t3 options.
Exits to global configuration mode.
Enters controller configuration submode and specifies the
controller name and instance identifier with the
rack/slot/module/port/name/instance notation. The controller
names are:
•
e3—TUG3 path carrying E3
t3—TUG3 path carrying T3
•
e1—channelized E1 port
•
In this step, you can create an E3 or T3 controller and add
Note
T1 channels under the T3 controller as shown in Step 14,
or you can create a channelized E1 port at this point.
E1 is not supported on the 1-Port Channelized
Note
OC-48/STM-16 SPA.
How to Configure Channelized SONET/SDH
HC-351