Acuity Brands 00194995254330 Hızlı Başlangıç Kılavuzu - Sayfa 7

Dış Mekan Işığı Acuity Brands 00194995254330 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Acuity Brands 00194995254330 10 sayfaları.

Sayfayı Yazdır

FIXTURE OPERATION

NOTE: During daylight all lights are off. Use the daylight sensor

dial to adjust light sensor sensitivity if desired.

1. MOTION SENSOR SETTINGS

If you like to test your light during the daytime

•

Set MODE dial to the TEST position to disable the photocell

and allow light to come on during daylight hours.

•

Walk across your motion detection zone (40ft/180degree).

Note: Walk in a zigzag direction. Walking up to the motion

detector in a straight line may keep you in between detection

regions, and your light will not come on.

•

If you find motion detection is to sensitive use MOTION dial

to reduce sensitivity.

Note: Factory setting is at highest sensitivity. The sensitivity can

be adjusted to increase or decrease detection if desired. Adjust

the sensitivity as needed. If sensitivity is set too high it may cause

false triggering.

2. TIME SETTING

Once Motion detection is confirmed, set the time you want the

light to stay on after motion stops.

•

Set MODE dial to 1M (minute) or 5M (minutes)

CAN THE LIGHTS STILL BE TURNED

ON/OFF WITH A LIGHT SWITCH?

At night Lights can be turned on or off manually with a wall switch

or circuit breaker in the Manual Override Mode.

MANUAL OVERRIDE

NOTE: MODE dial must be set at 1M or 5M to use manual

override

To disable the motion sensor and keep the light continuously on

for the night, flip the wall switch off for 5 seconds and then back

on.

To reset to Security mode, flip the switch off again for 5 seconds

and then back on.

If you leave the light on all night it will automatically turn off at

dawn and reset to Security mode.

NOTE: If you get confused while switching modes, turn the power

at the breaker or wall switch off for one minute, then back on. After

the calibration time, the control will be in the Security mode.

SETTING THE MOTION SENSOR

page 4

5 Seconds OFF then...

...back on