Cisco LINKSYS RFC 1483 Hızlı Kurulum Kılavuzu - Sayfa 2

Ağ Geçidi Cisco LINKSYS RFC 1483 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. Cisco LINKSYS RFC 1483 6 sayfaları. Linksys adsl gateway

Sayfayı Yazdır

Installation

Make sure that all the devices that you are working with are powered

down, including your computer(s) and the Gateway. If you have a

modem connected to your network, disconnect it. The Gateway

replaces your modem.

Connect one end of the

provided Ethernet cable to your

computer's Ethernet adapter.

Connect the other end of the

Ethernet cable to one of the

Ethernet ports on the back of

the Gateway.

Repeat step B for every computer or device that you want to connect to

the Gateway via Ethernet. If you connect more than four computers to

the Gateway, then you also need to connect a switch to the Gateway.

NOTE:

refer to the Ethernet adapter's documentation for more

information.

Connect one end of the phone

cable to the DSL port on the

back of the Gateway.

Connect the other end of the

phone cable to the wall jack

with ADSL service or microfilter.

NOTE:

microfilter or splitter between the phone cable and wall

jack. Contact your ISP to determine if one is required. (UK

residents need to connect the microfilter to the wall phone

jack with ADSL service, and then connect one end of the

provided phone cable to the DSL port on it.) If you have more

than one phone and you experience static on the line after

installing the Gateway, then you need to install an additional

microfilter for each phone or fax that you use. If you use

ISDN, then you do not need a microfilter.

If your computer's Ethernet adapter is not set up,

To avoid interference, you may need to place a

Connect the Computer

Connect the DSL