Cisco VG202 Yazılım Yapılandırma Kılavuzu - Sayfa 45
Ağ Geçidi Cisco VG202 için çevrimiçi göz atın veya pdf Yazılım Yapılandırma Kılavuzu indirin. Cisco VG202 50 sayfaları. Voice gateways
Ayrıca Cisco VG202 için: Donanım Kurulum Kılavuzu (50 sayfalar), Manuel (10 sayfalar), Donanım Kurulum Kılavuzu (48 sayfalar), Hızlı Başlangıç Kılavuzu (19 sayfalar)
Sayfayı Yazdır
Appendix A
Using the ROM Monitor
Changing the Configuration Register Manually
To change the virtual configuration register from the ROM monitor manually, enter the confreg
command followed by the new value of the register in hexadecimal format, as shown in the following
example:
rommon 1 > confreg 0x2101
You must reset or power cycle for new config to take effect
rommon 2 >
The value is always interpreted as hexadecimal. The new virtual configuration register value is written
into NVRAM but does not take effect until you reset or reboot the voice gateway.
Changing the Configuration Register Using Prompts
Entering the confreg command without an argument displays the contents of the virtual configuration
register and a prompt to alter the contents by describing the meaning of each bit.
In either case, the new virtual configuration register value is written into NVRAM but does not take
effect until you reset or reboot the voice gateway.
The following display shows an example of entering the confreg command:
rommon 7> confreg
enabled are:
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
enable
enable
enable
enable
enable
enable
change console baud rate? y/n
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400
change the boot characteristics? y/n
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
Configuration Summary
enabled are:
diagnostic mode
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n
You must reset or power cycle for new config to take effect
OL-16191-01
Configuration Summary
"diagnostic mode"? y/n
"use net in IP bcast address"? y/n
"load rom after netboot fails"? y/n
"use all zero broadcast"? y/n
"break/abort has effect"? y/n
"ignore system config info"? y/n
[0]:
0
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
[n]:
y
[n]:
y
[n]:
[n]:
[n]:
[n]:
[n]:
[n]:
y
[0]:
[n]:
y
[n]:
Configuration Register
0
A-5