Cisco VG202 Donanım Kurulum Kılavuzu - Sayfa 42

Ağ Geçidi Cisco VG202 için çevrimiçi göz atın veya pdf Donanım Kurulum Kılavuzu indirin. Cisco VG202 50 sayfaları. Voice gateways
Ayrıca Cisco VG202 için: Yazılım Yapılandırma Kılavuzu (50 sayfalar), Manuel (10 sayfalar), Donanım Kurulum Kılavuzu (48 sayfalar), Hızlı Başlangıç Kılavuzu (19 sayfalar)

Sayfayı Yazdır

Initial Configuration Procedures

Enter no to proceed with manual configuration using the command-line interface (CLI):

Step 2

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]

Press Return to terminate autoinstall and to continue with manual configuration.

Step 3

Several messages appear, ending with lines similar to the following:

...

Compiled <date> <time> by <person>

Step 4

Press Return to bring up the voice gateway prompt:

...

flashfs[4]: Initialization complete.

VG>

Enter privileged EXEC mode:

Step 5

VG> enable

VG#

Continue with the

Step 6

If the

Note

the ROM monitor, see the voice gateway rebooting and ROM monitor information in the

Configuration Fundamentals Configuration Guide

Initial Configuration Procedures

This section shows how to prepare the Cisco VG202 and Cisco VG204 to perform basic communication

functions. You may initially configure your voice gateway by using the Cisco IOS command-line

interface (CLI) or by using the setup command facility. To create the initial configuration, the setup

command facility prompts you for basic information about your voice gateway and network.

Cisco IOS CLI

To configure the initial voice gateway settings by using Cisco IOS CLI, follow these steps:

Set up a console connection to your voice gateway. The following message is displayed:

Step 1

...

voice gateway con0 is now available

Press Return or Enter. The following message is displayed:

Step 2

Cisco Configuration Professional Express (Cisco CP Express) is installed on this device.

This feature requires the one-time use of the username "cisco"

with the password "cisco." The default username and password have a privilege level of 15.

Please change these publicly known initial credentials using Cisco CP Express or the Cisco

IOS CLI.

Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide

4-2

"Initial Configuration Procedures" section on page

prompt appears, your system has booted in ROM monitor mode. For information on

rommon 1>

Chapter 4

Powering On the Cisco VG202 and Cisco VG204 Voice Gateways

for your Cisco IOS software release.

4-2.

Cisco IOS

OL-15959-01