Epson RX500 - Stylus Photo Color Inkjet Buradan Başlayın Kılavuzu - Sayfa 6

Tarayıcı Epson RX500 - Stylus Photo Color Inkjet için çevrimiçi göz atın veya pdf Buradan Başlayın Kılavuzu indirin. Epson RX500 - Stylus Photo Color Inkjet 9 sayfaları. Product support bulletin(s)
Ayrıca Epson RX500 - Stylus Photo Color Inkjet için: Kullanıcı El Kitabı (15 sayfalar), Kullanıcı Kılavuzu (20 sayfalar), Ürün Bilgi Formu (4 sayfalar), Teknik Özellikler (2 sayfalar), Kurulum Kılavuzu (2 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Güncelleme (1 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürün Destek Bülteni (1 sayfalar), Eğitim Kılavuzu (4 sayfalar)

Sayfayı Yazdır
Epson RX500 - Stylus Photo Color Inkjet Buradan Başlayın Kılavuzu
9
When you see a message that you have successfully installed the
RX500 drivers, click Next.
10
Continue following the instructions on the screen to install the rest of
your software.
Note: Installation may take several minutes. Don't cancel the
installation or start other programs.
11
When installation is finished, click Print Test Page to make sure your
software is installed correctly.
12
After the test page prints, click Exit.
13
Register your RX500 as instructed, then remove the CD-ROM.
Now you're ready to copy, scan, and print. See "Any Questions?" to the right
to find out how.
Macintosh
1
Insert the Epson CD-ROM in your CD-ROM or DVD drive.
2
Mac
®
OS X: Double-click the EPSON CD-ROM icon, then double-click
the
EPSON OS X Installer icon.
Mac OS 8.6 to 9.x: Double-click the
Installer icon.
3
When you see this screen,
click Install.
4
Read the license agreement and
click Agree to continue.
5
Follow the instructions on the
screen to install the software. You
may need to enter your
administrator password.
Note: Installation may take several minutes. Don't cancel the
installation or start other programs.
6
When prompted, restart your Macintosh. Then double-click your
EPSON CD-ROM icon, if necessary, and double-click your
installer icon to continue with installation.
7
When you see this screen, click
Install to finish installing your
software.
Note: Installation may take several
minutes. Don't cancel the
installation or start other programs.
8
At the end of installation, click Exit.
9
Register your RX500 as instructed,
then remove the CD-ROM.
10
Make sure the RX500 is turned on, then
lift up the scanner.
11
Remove the yellow sticker and plug the
square end of a USB cable into the USB
port on the RX500. Then route the cable in
the slot as shown.
Caution: Make sure the USB cable fits securely into the slot. The
USB connector may snap if the cable is not routed correctly and
the scanner is closed with force.
12
Close the scanner carefully.
13
Plug the flat end of the cable into any available USB port on your
Macintosh.
EPSON OS 8 and 9
continue