Acuity Brands NaviLite N1L Kurulum Talimatları

Işık Fikstürü Acuity Brands NaviLite N1L için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Acuity Brands NaviLite N1L 3 sayfaları. For led emergency lighting fixture

Sayfayı Yazdır
FOR LED EMERGENCY LIGHTING FIXTURE
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
IMPORTANT SAFEGUARDS:
SAVE THESE INSTRUCTIONS
IMPORTANT: Let the battery charge up for at least 24 hours. Then normal operation of this unit should take
effect. To check, press the "TEST" button. The LED lamps on the unit should turn ON. During an electrical
power failure, the led lamps will automatically come on for a minimum of 90 minutes. In accordance with
NFPA 101, your emergency lighting system must be tested monthly for a minimum of 30 seconds and
annually for 90 minutes. Refer to your local codes for any additional requirements that may apply.
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY RESULT IN
DEATH, SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE - For your protection, read and follow
these warnings and instructions carefully before installing or maintaining this equipment. These instructions
do not attempt to cover all installation and maintenance situations.
WARNING: RISK OF FIRE - Lamps are hot. Keep combustible material away from hot parts. Observe lamp
manufacture's warnings, recommendations and restrictions on lamp operation and maintenance. Make sure
lamps are correctly installed.
•
All service shall be performed by qualified service personnel. This product must be installed and
maintained in accordance with the applicable installation codes by a person familiar with the construction
operation of the product and the hazards involved.
•
This product must be installed in accordance with the applicable installation codes and ordinances.
•
Before wiring to power supply, turn off electricity at fuse or circuit breaker.
•
Disconnect A.C. power and unplug battery before servicing.
•
Consult your local building code for approved wiring and installation.
•
May be used outdoors under cover. (0°C-50°C).
Do not let power supply cord touch hot surfaces.
•
•
Do not mount near gas or electric heater.
Equipment should be mounted in locations and at heights where it will not readily be subjected to
•
tampering by unauthorized personnel.
•
The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
•
Do not use this equipment for other than intended use.
• The AC voltage rating of this equipment is specified on the product label.
Do not connect equipment to any other voltage.
©2016 Acuity Brands Lighting, Inc.
INSTALLATION INSTRUCTIONS
One Lithonia Way, Conyers GA 30012
Printed in the USA Rev 8/2017
Phone: 800-334-8694
3
P3508
pg 1 of