Acuity Brands CPANL DCMK 14 Kurulum Talimatları Kılavuzu - Sayfa 7
Raflar ve Standlar Acuity Brands CPANL DCMK 14 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Acuity Brands CPANL DCMK 14 17 sayfaları. Surface mount kit
Sayfayı Yazdır
8
Raise front of fixture to ceiling and engage latches –
Gently push CPANL toward hinges to fully seat in back of bracket and rotate latch side of fixture up towards ceiling.
If tether is sticking out, push it so that it lays on top of panel. May need to align it so that clip does not prevent panel from going up fully.
Panel will need to be close enough to ceiling for locking feature on latch tab to clear opening in hanger bracket.
Rotate latches into closed position (both latches), see Figure 8A.
Latch tabs should be flush against side of fixture, see Figure 8B
Gently let down fixture to make sure latches are engaged.
Figure 8A
If the CPANL needs to be removed from the hanger bracket (not necessary during typical installation) –
To unlatch: Lift latch side of panel toward ceiling to clear hook feature and pull on latches.
Unclip the front tethers.
Have someone hold ladder steady; and then securely take hold of panel and rotate latch side toward ceiling until the front is 12"-18" from
ceiling.
Use your finger, or a flat head screwdriver, to push locking spring above mounting hinge, see Figure.
Carefully slide the mounting hinge toward you, past the locking spring. Repeat on other side to fully free fixture.
Lower panel to the ground and place on flat surface to avoid damaging the diffuser lens.
(2x)
Figure (only for CPANL removal)
12/8/2020 Rev C
CPANL SURFACE MOUNT KIT - INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION DE CPANL KIT DE MONTAGE EN SURFACE
INSTRUCCIONES DE INSTALACIÓN DE CPANL KIT DE MONTAJE EN SUPERFICIES
1
2
FOR ANY QUESTIONS, PLEASE CONTACT 1-800-705-7378
! PLEASE RETAIN THESE INSTRUCTIONS !
Figure 8B
CAUTION:
1)
You should be able to gently pull the panel in any
direction without it disengaging from the mounting
bracket.
2) The DCMK Bracket is only intended for use on a smooth
flat ceiling surface.
Page 6 of 16