Digizoid ZOFS Hızlı Başlangıç Kılavuzu - Sayfa 2

Amplifikatör Digizoid ZOFS için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Digizoid ZOFS 2 sayfaları.

Sayfayı Yazdır

ZO's Volume Control

ZO is designed to work with a wide range of headphones

without the need for multiple gain modes. Because ZO

doesn't utilize gain modes, its volume control includes

both attenuation and gain levels:

Volume

Levels

Attenuation/Gain

0 to 174

Attenuation (0.5 dB steps)

175 to 210

Gain (0.5 dB steps)

To get the best sound quality, set your source's volume

between 75-100% (unless it's a fixed output), and then use

ZO to attenuate or amplify the audio signal. If you're using

a sensitive headphone or IEM (> 100 dB/mW), you will

most likely need to attenuate the output (volume levels <

174). If you're using a high impedance headphone or one

with less sensitivity, you will probably need to amplify the

output (volume levels > 175).

Applications

Did you know ZO can make more than just your

headphones sound better? Try it in the car, with your

gaming gear, or with your computer speakers!

Troubleshooting

Hearing hiss/noise

• If using a smartphone, noise may be from radio wave

interference. Change the device's communication mode

to one that blocks communication signals, such as

airplane mode.

• Plug your headphones in to the ZO, but do not connect

your audio source. Turn ZO on. If no noise is heard, then

the player or the track could be generating the noise.

• Incorrect volume level settings may result in audible

noise levels if you're using high sensitivity headphones

or IEMs. Please review the section ZO's Volume Control

above.

• If charging, use a USB wall adapter instead of a

computer.

Undesirable Sound Quality

• Make sure the battery is fully charged.

• Turn off all sound enhancements such as EQ, virtual

surround sound/3D effects or noise cancelation.

Attenuation/

Gain Amount

• Improper setup of volume levels and SVT settings may

cause clipping or other audible distortion. Please visit

-87.15 to -0.15 dB

www.digizoid.com/support for more information.

0.35 to 17.85 dB

• Highly compressed tracks may already include some

amount of clipping and distortion. This may become

more apparent during playback with ZO. To learn more,

visit www.digizoid.com/support

Not hearing anything/faint/intermittent sound

• Check that ZO is turned on and correctly connected

• Turn up player's volume

• Turn up ZO's volume

• Make sure plugs are fully inserted

• Try different cables

• Fully charge ZO's battery

Doesn't turn on

• Fully charge ZO's battery

Battery doesn't charge.

• Make sure the port is USB 2.0

• Check if computer is on and out of sleep mode

• Try a different USB power source

• Try a different charging cable

If you're still experiencing issues or have other questions,

please feel free to contact us at www.digizoid.com/

contact, or email us at [email protected].

To avoid damage to your hearing, do not listen at high volume

levels for extended periods of time. If you experience ringing in

your ears, reduce the volume level to prevent permanent damage.

SmartVektor and ZO are trademarks or registered

trademarks of digiZoid Inc.