Epson DLQ-3500 Hızlı Kılavuz - Sayfa 28

Yazıcı Aksesuarları Epson DLQ-3500 için çevrimiçi göz atın veya pdf Hızlı Kılavuz indirin. Epson DLQ-3500 32 sayfaları. Epson serial impact dot matrix printers
Ayrıca Epson DLQ-3500 için: Kurulum Kılavuzu (31 sayfalar), Uyarı (1 sayfalar), Referans Kılavuzu (34 sayfalar)

Sayfayı Yazdır

Micro Adjust Function

The Micro Adjust function allows you to

move the paper forward or backward in

0.141 mm (1/180-inch) increments so

that you can make precise adjustments

to the top-of-form and tear-off positions.

Adjusting the tear-off position

If your paper perforation is not aligned with

the tear-off edge, you can use the Micro

Adjust function to move the perforation to

the tear-off position.

Follow these steps to adjust the tear-off

position:

Caution:

Never use the knob to adjust the tear-off

position; this may damage the printer or

cause it to lose the tear-off position.

Note:

Your tear-off position setting remains in effect

until you change it, even if you turn off the

printer.

1. Press the Pause button if the printer is

printing.

2. Make sure the Tear Off/Special Paper

lights are flashing (the paper is at the

current tear-off position). You may need

to press the Tear Off/Special Paper

button to advance the paper to the

tear-off position.

3. Hold down the Pause button for about

three seconds. The Pause light begins

flashing and the printer enters the Micro

Adjust mode.

EPSON DLQ-3500 Quick Guide

4. Press the LF/FF D button to feed paper

backward, or press the Load/Eject U

button to feed paper forward, until the

paper perforation is aligned with the

tear-off edge of the printer cover.

Note:

The printer has a minimum and a maximum

tear-off position. If you try to adjust the

tear-off position beyond these limits, the

printer beeps and stops moving the paper.

5. Tear off the printed pages.

6. Press the Pause button to exit the Micro

Adjust mode.

When you resume printing, the printer

automatically feeds the paper back to the

top-of-form position and begins printing.

Micro Adjust Function (3/4)

Pause

Paper Out

3sec

Micro Adjust

LF/FF

Load/Eject