DIGWDF ESP/XBee Snap-In Kullanıcı Kılavuzu

Adaptör DIGWDF ESP/XBee Snap-In için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. DIGWDF ESP/XBee Snap-In 9 sayfaları. Wireless adapter board

Sayfayı Yazdır

DIGWDF XBee/ESP Snap-In

Assembly & User Guide

Overview

The ESP/XBee Snap-In is a small, inexpensive multi-purpose wireless adapter

board. It can facilitate using an XBee radio or the ESP-01 module for wireless

reception or the XBee radio if used as a transmitter. Created in 2011, it was the

first adapter that was designed to plug directly into the U5 ST485BN socket of

the Renard SS8, SS16 or SS24 controller for wireless control using the tried-and-

tested XBee radio. With the addition of a 5-pin Renard Plus female header, the

Snap-in can plug directly onto the header of the same configuration on any

Renard Plus controller. Subsequent developments in the wireless industry have

expanded its capability with the inexpensive ESP8266 module for full Wi-Fi

control in place of the popular XBee. The Snap-In is primarily used as a

receiving unit but can also be used as a transmitter or XBee programmer when

using an XBee radio and interfaced to a computer via an inexpensive USB->TTL

adapter.

BOM – Bill of Materials

QTY

3.3v regulator, 500ma (optional, but preferred part)

3.3v regulator, 800ma (cheaper substitute for above)

3.3v regulator 100ma (optional – for XBee in receive mode only

.1uf non-polarized capacitor

100uf 16-volt electrolytic capacitor (optional, for ESP)

5-pin male header (optional)

1x5 female header (optional)

2-pin male header (optional)

Jumper shunt (optional)

Female XBee headers (optional, for XBee only)

1x4 stackable headers (optional)

3.3v Zener diode (optional, Xmit mode only)

XBee module (optional, use Series 1 only)

ESP8266 module (optional, use ESP-01 style)

2x4 female header (optional, ONLY if ESP8266 module is used)

Parts substitutions

Notice that almost every part is listed as 'optional!' This is because there are many options for

building and using this adapter. Before ordering or installing any parts, the user is highly

encouraged to READ THROUGH this guide to determine exactly how the adapter will be used first

because suggestions will be made for which parts are needed for various configurations. Here are a

few starting guidelines:



If you plan to use an XBee radio in receive mode only, the lower-output L78L33 voltage

regulator will suffice; otherwise, the UA78M33 or LM1117T regulator is required.



If you plan to use the ESP8266 module, you do not need the female XBee headers, the 2-pin

header and shunt jumper or the 3.3 Zener diode. You cannot transmit with the ESP8266

module and this adapter.

Description

DIGWDF XBee/ESP Snap-In Assembly & User Guide – v 20170308 -Page 1

Part #

UA78M33CKCS

Mouser.com

LM1117T

Taydaelectronics.com

L78L33

Taydaelectronics.com

Source