TomTom LINK 300 Kullanıcı Kılavuzu - Sayfa 2

Uzaktan Kumanda TomTom LINK 300 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. TomTom LINK 300 46 sayfaları. Logbook
Ayrıca TomTom LINK 300 için: Manuel (5 sayfalar)

Sayfayı Yazdır

Borna_Logbook.book Page 3 Thursday, January 21, 2010 9:53 AM

Inserting the batteries

1. Hold the sides of the Remote LINK and press the latch on

the back of the device to open the battery compartment.

2. Insert the batteries (2 x AAA/LR3) in the Remote LINK.

Make sure you insert the batteries in the correct way, as

shown inside the battery compartment.

3. Replace the battery cover.

Establishing a paired connection

The following instructions only apply if your Remote LINK has

not been connected to a TomTom LINK 300/310. Press any key

to turn on your Remote LINK and see "Understanding your

Remote LINK" to check the status of the device.

If the device is not paired with a LINK 300/310, then do the

following.

1. Make sure the LINK 300/310 is properly installed in the

vehicle.

2. Turn on the ignition.

3. Make sure there are no other vehicles installed with a LINK

300/310 located within a distance of 30 metres.

4. Press any key on your Remote LINK to switch it on.

If the LEDs on all three buttons are flashing, then the device

is not paired and you need to continue with the next step.

5. Press any two buttons at the same time until you hear a

sound.

Preparing your Remote LINK

Pre-

par-

ing

your

Re-

mote

LINK