Epson LQ-1070+ Ürün Destek Bülteni

Yazıcı Aksesuarları Epson LQ-1070+ için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson LQ-1070+ 5 sayfaları. Product support bulletin(s)
Ayrıca Epson LQ-1070+ için: Ürün Destek Bülteni (20 sayfalar), Ürün Bilgi Kılavuzu (8 sayfalar), Kurulum Kılavuzu (1 sayfalar), Ürün Bilgi Kılavuzu (8 sayfalar), Ürün Destek Bülteni (16 sayfalar)

EPSON AMERICA, INC.

Product Support Bulletin

Subject: DFX-5000, DFX-8000 and Avatar EP-Connect

Date: 10/9/92

Page(s): 1 of 1

Avatar Corporation distributes the EP-Connect coax interface for the Epson DFX-

series and other Epson dot-matrix printers that use A-type interfaces. This EP-

Connect coax interface allows a connection to an IBM 3174/3274/3276 control unit

or 4300 series Display Printer Adaptor using standard type A coaxial cable.

When using EP-Connect and the DFX-series printers, there have been some

intermittent operational problems reported. It has been determined that this is

caused by the type of connector used on the EP-Connect interface that plugs into

the printer's main controller board. There are two types of connectors that have

been used on the EP-Connect coax interface. One type is a "FUJITSU" connector.

The other is a "HONDA" connector. The "FUJITSU" connector has slightly shorter

pins than the "HONDA' connector. Epson America, Inc. does

use of the EP-Connect interface that has the 'FUJITSU' connector unless it is used

on a unit that has the countermeasure described below.

To identify which connector type the EP-Connect interface has, simply look directly

at the interface connector. The "HONDA" connector will have the name "HONDA

printed directly on the black part of the connector. If there is no label, it is the

"FUJITSU" connector. Epson America, Inc. recommends the "HONDA" connector.

There are approximately 1,600 of the EP-Connect interfaces on the market that

contain the non-approved "FUJITSU" connector. To accommodate these interfaces

Epson has taken a countermeasure on the DFX series printers. This involves

adjusting the position of the ORII/F circuit board and changing the securing points.

As a result, Epson only recommends the use of the Avatar board with the

"FUJITSU" connector on DFX series printers that have the countermeasure

installed. The starting serial

installed is outlined below.

PRINTERS

DFX-5000

DFX-8000

If further information is needed on this subject, please contact Epson's Technical

Support Department. For additional information on the EP-Connect interface,

please contact Avatar Corporation at (508) 435-6872.

number for the printers that have the countermeasure

STARTING SN#

0G20A11434

ovzooo7714

PSB No: P-0091

Originator: REW

recommend the

not

EPSON