Epson LQ-570+ Ürün Destek Bülteni - Sayfa 3

Yazıcı Aksesuarları Epson LQ-570+ için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson LQ-570+ 20 sayfaları. Sdx acd manager 5.2 printer setup
Ayrıca Epson LQ-570+ için: Ürün Destek Bülteni (5 sayfalar), Ürün Bilgi Kılavuzu (8 sayfalar), Kurulum Kılavuzu (1 sayfalar), Manuel (12 sayfalar), Teknik Özellikler (2 sayfalar), Manuel (8 sayfalar), Ürün Destek Bülteni (16 sayfalar), Servis Kılavuzu (49 sayfalar), Kurulum Kılavuzu (14 sayfalar)

10 INPUT "Point Siie";A$

20 B=VAL(A$)*2

21 RESTORE 70

24 IF B=Y THEN GOT0 30

26CLS

27 PRINT A$ " is not a valid point size choice."

28 GOT0 10

30 C=VAL(A$)

40 LPRM CHR$(27);"X";CHR$(l);CHR$(B);CHR$(O);"n'lese are ";A$;" point

characters"

60 GOT0 10

70 DATA 0,16,20,21,24,28,32,36,40,4~44,48,52,56,60,64

Line 10 - allows you to specify the point size desired.

Line 20 - computes the value for "nl" in the ESC X command.

tine 21 - check to ensure that a valid point size was input tf the point size is

valid, the program jumps to line 30. tf the point size is not valid, the

program prints a message on the screen and starts over again.

Line 30 - computes the value for "nl " for advancing paper using the ESC ( v

command.

Line 40 - sends the "Set Pitch and Point Size" command to the printer. (Note: The

pitch is set for proportional spacing for ail point sizes to ensure proper

character spacing regardless of the point size.)

Line 50 - sends the "Set Relative Vertical Position" command to the printer. This

command advances the paper in preparation for printing the next line.

NOTE: To hatt the program, hold down the "CM key and press the "c" key.

PSB No: P-0082

Page: 3 of 14