Epson LQ-570+ Ürün Destek Bülteni - Sayfa 8

Yazıcı Aksesuarları Epson LQ-570+ için çevrimiçi göz atın veya pdf Ürün Destek Bülteni indirin. Epson LQ-570+ 20 sayfaları. Sdx acd manager 5.2 printer setup
Ayrıca Epson LQ-570+ için: Ürün Destek Bülteni (5 sayfalar), Ürün Bilgi Kılavuzu (8 sayfalar), Kurulum Kılavuzu (1 sayfalar), Manuel (12 sayfalar), Teknik Özellikler (2 sayfalar), Manuel (8 sayfalar), Ürün Destek Bülteni (16 sayfalar), Servis Kılavuzu (49 sayfalar), Kurulum Kılavuzu (14 sayfalar)

Sayfayı Yazdır
Epson LQ-570+ Ürün Destek Bülteni
C f V m1 m2 n1 a is the command for changing the print position vertically (with
respect to the Top of Form position) in units where ml, m2, nl and n2 are variables.
command. Currently, the values for ml and m2 MUST be ml =2 'and m2=0.
To determine the values for nl and n2 perform the following steps.
1.
Determine the desired vertical dice from the Top of Form in inches.
2
3.
Divide the resutt by 258 using long division.
4.
The remainder in the quotient from step 3 is the value for nl.
5.
EXAMPLE
1.
2
3.
4.
5.
In the Basic programming language, the command would look like this.
current Top of Form setting. For example, if the Top of Form setting is the top edge
of the paper, the paper will be positioned so that the printer is ready to print 1 inch
down from the top edge of the paper.
PSB No: P-0082
Page: 8 of 14