Acuity Brands Lighting AFFINITY AFF OELR Manuel - Sayfa 3

Aydınlatma Ekipmanları Acuity Brands Lighting AFFINITY AFF OELR için çevrimiçi göz atın veya pdf Manuel indirin. Acuity Brands Lighting AFFINITY AFF OELR 16 sayfaları. Led remote light

Sayfayı Yazdır

SURFACE CONDUIT MOUNTING

NOTE: to avoid interference with components in the housing, use the most compact wire connectors appropriate to the wire gauge.

PREPARING THE UNIT FOR CONDUIT :

Remove the conduit plug from inside. The unit

is threaded to accept 1/2" NPT threads (14

TPI), which are common in rigid conduit and

EMT connector products. Rigid conduit or

EMT fittings can be directly threaded into the

housing without the need for a locknut, or for

wet locations, use an approved wet location

fitting.

Sized for ½" conduit

* A right angle screwdriver may be required to break

the plug from the paint

FINAL ASSEMBLY

Ensure all wires and

connectors are routed to

avoid interference with other

components. Line up the

Alignment pins (located at

diagonally opposite corners

of the front housing) with the

mating receptacles (two on

the rear housing).

SWITCH AIMING (FCT optics)

Note: Ships standard as WT option (wide throw mode)

Press and hold "Forward/Wide" button (Refer Page 5, Fig 1) for about 9 seconds to switch light beam aiming.

AFFINITY

INSTALLATION and WIRING

Conduit plug

To properly close the unit, it is

important to push the cover

straight onto the rear housing.

If the pins are not aligned with

the receptacles, the housing

will not close properly. Make

sure there are no gaps

between the front and rear

housings. If gap is present,

open the unit and reinstall the

front housing.

LIFE SAFETY SOLUTIONS

TEL: 800-705-SERV (7378)

[email protected]

BRANCH CIRCUIT WIRING :

The wiring compartment is sized for (3) incoming 12 AWG wires

and (3) outgoing 12 AWG wires and common wire connectors. If

your branch circuit is a larger AWG or you have a need for a

through-wire application, install the branch circuit raceway such

that you do not have to pass the circuit through the fixture.

Open

(Clockwise) *

Sheet metal

clip

Alignment pin

www.lithonia.com

Page 3

912-00021-002

Rev. CA, 2/2020